D-Link DXS-3600-EM-8XS CLI Guide - Page 187

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example show how to download the config.cfg from a TFTP server using VPN and replace the current running configuration with it. DXS-3600-32S#configure replace tftp: //10.0.0.66/config.cfg vrf VPN1 This will apply all necessary additions and deletions to replace the current running configuration with the contents of the specified configuration file, which is assumed to be a complete configuration, not a partial configuration. [y/n]: y Accessing tftp://10.0.0.66/config.cfg... Transmission start... Transmission finished, file length 45422 bytes. Executing script file config.cfg ...... Executing done DXS-3600-32S# 9-5 boot config flash This command is used to specify the filename of the configuration file, stored in the NVRAM, from which the system configures itself during initialization (boot-up). boot config flash FILENAME Parameters FILENAME Specifies the name of the configuration file, stored in the NVRAM. For example, 'config.cfg'. Default Command Mode Command Default Level Usage Guideline The default startup configuration file is 'config.cfg'. Global Configuration Mode. Level: 15 The command is used to specify the boot-up configuration file. The default boot-up configuration file is called 'config.cfg'. If the boot-up configuration file is deleted, the system will choose a valid configuration file and set it as the boot-up configuration file. If there is no valid configuration file, the device will be configured to default state when boot-up next time. To verify your configuration, use show boot in privileged mode. Example This example shows how to configure the configuration file, called 'config.cfg', as the boot-up configuration file, from which the system configures itself during initialization. DXS-3600-32S#configure terminal DXS-3600-32S(config)#boot config flash config.cfg DXS-3600-32S(config)# 9-6 copy running-config This command is used to save the current running configuration to the NVRAM. This command is also used to save and set the current running configuration as the boot-up configuration file or upload the current running configuration to the TFTP server or FTP server. copy running-config {bootup-config | flash: [FILENAME] | {tftp: [//location/filename] | ftp: [// username:password@location:tcpport/filename]} [vrf VRFNAME]} 179