D-Link DXS-3600-EM-8XS CLI Guide - Page 259

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide GARP VLAN Registration Protocol (GVRP) Commands 22-1 clear gvrp statistics interface This command is used to clear the statistics for a GVRP port. clear gvrp statistics [interface INTERFACE-ID [, | -]] Parameters INTERFACE-ID , - (Optional) Specifies the interface to clear. If no interface is specified the statistics on all interfaces will be cleared. (Optional) Specifies a series of interfaces, or separate a range of interfaces from a previous range. (Optional) Specifies a range of interfaces. Default Command Mode Command Default Level Usage Guideline None. Privilege EXEC Mode. Level: 12 This command clears the GVRP counters. If the INTERFACE-ID is not specified, then all GVRP counters will be cleared. Example This example shows how to clear statistics on all interfaces. DXS-3600-32S#clear gvrp statistics DXS-3600-32S# 22-2 gvrp (Global) This command is used to enable the GVRP function globally, and use the no gvrp command to disable the GVRP function globally. gvrp no gvrp Parameters Default Command Mode Command Default Level Usage Guideline None. By default, this option is disabled. Global Configuration Mode. Level: 12 The user should enable the global GVRP state and individual port's GVRP state and start GVRP on the port. Once the GVRP is enabled globally, the GVRP PDU will be captured to CPU to process. Otherwise, the GVRP will be forwarded in the portbased VLAN of the reception port. Example This example shows how to enable the GVRP protocol global state. DXS-3600-32S#configure terminal DXS-3600-32S(config)#gvrp DXS-3600-32S(config)# 22-3 gvrp (Interface) This command is used to enable the GVRP function on a port, and use the no gvrp command to disable the GVRP function on a port. 251