D-Link DXS-3600-EM-8XS CLI Guide - Page 395

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to set the distribute list in on the System interface. DXS-3600-32S#configure terminal DXS-3600-32S(config)#router ospf DXS-3600-32S(config-router)#distribute-list 3 in System DXS-3600-32S(config-router)# 40-12 ip ospf authentication This command is used to configure the authentication type for an OSPF interface. Use the no command to restore to default value. ip ospf authentication [{message-digest | null}] no ip ospf authentication Parameters message-digest null (Optional) Specifies to use the MD5 authentication. (Optional) Specifies that no authentication is used. Default Command Mode Command Default Level Usage Guideline By default no authentication is configured. Interface Configuration Mode. Level: 8. (EI Mode Only Command) The authentication type can be simple password authentication or MD5 authentication. Use no ip ospf authentication or ip ospf authentication null command to remove the authentication. Users can verify the settings by entering the show ip ospf interface command. Example This example shows how to set the System interface (VLAN 1) authentication type to simple password. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#ip ospf authentication DXS-3600-32S(config-if)#ip ospf authentication-key yourpass DXS-3600-32S(config-if)# Example This example shows how to set the System interface (VLAN 1) authentication type to MD5. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#ip ospf authentication message-digest DXS-3600-32S(config-if)#ip ospf message-digest-key 10 md5 yourpass DXS-3600-32S(config-if)# Example This example shows how to remove the authentication on System interface (VLAN 1). DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#ip ospf authentication null DXS-3600-32S(config-if)# 387