Dell 2355DN Service Manual - Page 76
Display message, Meaning, Suggested solutions, Turn the ECM mode on. See ECM - scan to email
View all Dell 2355DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Alignment and Troubleshooting Display message Meaning Invalid Cartridge Cartridge is not valid for this machine The toner cartridge you have installed is not for your printer. IP Conflict IP address conflict. The network IP address you have set is being used by someone else. Fax Job is completed with The received fax number is the error Incompatiable number stored Job cannot be accepted The receiving party did not answer or because line is busy the line is already engaged. Line Error Your printer cannot connect with a remote printer or has lost contact because of a problem with the phone line. OR No dial tone sounds Check Fax Line Fax Job is completed with The printer has a communication error : Line Error problem. Low Heat Error Power Cycle There is a problem in the fuser unit. LSU Hsync Error Power A problem has occurred in the Laser Cycle Scanning Email Job is completed with error : Mail excced server support Email Job is completed with error : Mail too large Memory Full The mail size is larger than the supported size by SMTP server. Single page data exceeds the configured mail size. The memory is full. Suggested solutions Install a Dell-genuine toner cartridge, designed for your printer. Check the IP address and reset it if necessary Change the Junk Fax Setup option. Try again after a few minutes. - Try again. If the problem persists, please wait for an hour or try a different phone line if possible and then try to connect again. - Turn the ECM mode on. See ECM Mode. - Check that the phone line is connected properly. - Check that the phone socket in the wall is working by plugging in another phone. Ask the sender to try again. Unplug the power cord and plug it back in. If the problem persists, refer to the troubleshooting for Fuser Error. 1. Unplug the power cord and plug it back in. 2. Check if the connection between the LSU and the main board is correct. 3. If the problem persists, replace the LSU. Divide your mail or reduce the resolution. Reduce the resolution and try again. Delete unnecessary documents, retransmit after more memory becomes available. 4-36 Service Manual