Dell OptiPlex 5055 A Series Small Form Factor OptiPlex 5055 Small Form Factor - Page 24
Installing M.2 PCIe SSD, Heat sink assembly, Removing heat sink assembly
View all Dell OptiPlex 5055 A Series Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Installing M.2 PCIe SSD 1 Insert the M.2 PCIe SSD to the connector 2 Press the blue plastic tab to secure the M.2 PCIe SSD. 3 Install the: a optical drive b cooling shroud c 2.5 inch hard drive assembly d front bezel e cover 4 Follow the procedure in After working inside your computer. Heat sink assembly Removing heat sink assembly 1 Follow the procedure in Before working inside your computer. 2 Remove the: a cover b front bezel c 2.5 inch hard drive assembly d cooling shroud e optical drive 3 To remove the heat sink assembly: a Disconnect the heat sink assembly cable from the connector on the system board [1]. b Loosen the 6 captive screws that secure the heat sink assembly to the system board [2]. NOTE: Loosen the screws based on the numbers available on the system board. c Lift the heat sink assembly away from the computer [3]. 24 Disassembly and reassembly