Dell OptiPlex 5055 A Series Small Form Factor OptiPlex 5055 Small Form Factor - Page 40
Installing the system board
View all Dell OptiPlex 5055 A Series Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Installing the system board 1 Hold the system board by its edges and align it toward the back of the computer. 2 Lower the system board into the chassis until the connectors at the back of the system board. 3 Align with the slots on the chassis, and the screw holes on the system board align with the standoffs on the computer. 4 Replace the screws (12 lbs) to secure the system board to the computer. 5 Route all the cables through the routing clips. 6 Align the cables with the pins on connectors on the system board and connect the following cables to the system board: a intrusion switch b optical drive c hard drive d PSU e power switch f power distribution for optical drive and hard drive 7 Install the: a expansion card 40 Disassembly and reassembly