Dell PowerEdge 2300 Installation and Troubleshooting Guide - Page 30

Dell PowerEdge 2300, Systems User's Guide

Get Dell PowerEdge 2300 PDF manuals and user guides View all Dell PowerEdge 2300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Address mark not found Alert! Unbuffered and registered DIMMs cannot be mixed Auxiliary device failure Attachment failed to respond Bad errorcorrection code(ECC) on disk read Faulty diskette/tape drive subsystem or hard-disk drive subsystem (defective system board) Replace the system board. See Chapter 11, "Getting Help," for instructions on obtaining technical assistance. Combination of unbuffered and registered DIMMs installed Replace one or more DIMMs so that all DIMMs are the same type. See "Installing DIMMs" and "Removing DIMMs" in Chapter 8. Mouse cable connector Check the mouse cable loose or improperly con- connection. If the problem nected, defective mouse persists, replace the mouse. Diskette drive or harddisk drive controller cannot send data to associated drive Replace the drive's interface cable. Faulty diskette/tape drive subsystem or hard-disk drive subsystem (defective system board) Replace the system board. See Chapter 11, "Getting Help," for instructions on obtaining technical assistance. Controller has failed Data error Faulty diskette, diskette Replace the diskette, diskette drive, or hard-disk drive drive, or hard-disk drive. Decreasing available memory One or more DIMMs improperly seated or faulty Remove and reseat the DIMMs. See "Installing DIMMs" and "Removing DIMMs" in Chapter 8. If the problem persists, replace the DIMMs. Diskette drive 0 seek failure Diskette drive 1 seek failure Faulty or improperly inserted diskette, incorrect configuration settings in System Setup program, loose diskette/ tape drive interface cable, or loose power cable Replace the diskette. Run the System Setup program to correct the diskette drive type. See Chapter 4, "Using the System Setup Program," in the Dell PowerEdge 2300 Systems User's Guide for instructions. Check the diskette/tape drive interface cable and power cable connections to the drive. NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list that precedes the Index. 3-2 Dell PowerEdge 2300 Systems Installation and Troubleshooting Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
3-2
Dell PowerEdge 2300 Systems Installation and Troubleshooting Guide
7DEOH±¸¶´µ±±6\VWHP±0HVVDJHV
0HVVDJH
&DXVH
&RUUHFWLYH²$FWLRQ
Address mark
not found
Faulty diskette/tape drive
subsystem or hard-disk
drive subsystem (defec-
tive system board)
Replace the system board.
See Chapter 11, “Getting
Help,” for instructions on
obtaining technical assistance.
Alert!
Unbuffered and
registered
DIMMs cannot
be mixed
Combination of unbuf-
fered and registered
DIMMs installed
Replace one or more DIMMs
so that all DIMMs are the
same type. See “Installing
DIMMs” and “Removing
DIMMs” in Chapter 8.
Auxiliary
device failure
Mouse cable connector
loose or improperly con-
nected, defective mouse
Check the mouse cable
connection. If the problem
persists, replace the mouse.
Attachment
failed to
respond
Diskette drive or hard-
disk drive controller
cannot send data to
associated drive
Replace the drive’s interface
cable.
Bad error-
correction
code(ECC) on
disk read
Controller has
failed
Faulty diskette/tape drive
subsystem or hard-disk
drive subsystem (defec-
tive system board)
Replace the system board.
See Chapter 11, “Getting
Help,” for instructions on
obtaining technical assistance.
Data error
Faulty diskette, diskette
drive, or hard-disk drive
Replace the diskette, diskette
drive, or hard-disk drive.
Decreasing
available
memory
One or more DIMMs
improperly seated or
faulty
Remove and reseat the
DIMMs. See “Installing
DIMMs” and “Removing
DIMMs” in Chapter 8. If the
problem persists, replace the
DIMMs.
Diskette drive
0 seek failure
Diskette drive
1 seek failure
Faulty or improperly
inserted diskette,
incorrect configuration
settings in System Setup
program, loose diskette/
tape drive interface
cable, or loose power
cable
Replace the diskette. Run the
System Setup program to cor-
rect the diskette drive type.
See Chapter 4, “Using the
System Setup Program,” in
the
Dell PowerEdge 2300
Systems User’s Guide
for
instructions. Check the dis-
kette/tape drive interface cable
and power cable connections
to the drive.
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and
acronym list that precedes the Index.