Dell PowerEdge 2300 Installation and Troubleshooting Guide - Page 34

PowerEdge 2300 Systems, User's Guide - processors settings

Get Dell PowerEdge 2300 PDF manuals and user guides View all Dell PowerEdge 2300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

Memory parity interrupt at address Improperly seated or faulty DIMMs Remove and reseat the DIMMs. If the problem persists, replace the DIMMs. See "Installing DIMMs" and "Removing DIMMs" in Chapter 8. Memory tests terminated by keystroke POST memory test terminated by pressing No action is required. No boot device available Faulty diskette, diskette/ tape drive subsystem, hard-disk drive, harddisk drive subsystem, or no boot disk in drive A Replace the diskette or harddisk drive. If the problem persists, replace the system board. See Chapter 11, "Getting Help," for instructions on obtaining technical assistance. No boot sector on hard-disk drive Incorrect configuration settings in System Setup program, or no operating system on hard-disk drive Check the hard-disk drive configuration settings in the System Setup program. See Chapter 4, "Using the System Setup Program," in the Dell PowerEdge 2300 Systems User's Guide for instructions. No timer tick interrupt Defective system board Replace the system board. See Chapter 11, "Getting Help," for instructions on obtaining technical assistance. Non-system disk or disk error Faulty diskette, diskette/ tape drive subsystem, or hard-disk drive subsystem Replace the diskette or harddisk drive. If the problem persists, replace the system board. See Chapter 11, "Getting Help," for instructions on obtaining technical assistance. Not a boot diskette No operating system on Use a bootable diskette. diskette Processor or terminator card not installed! No microprocessor or terminator card installed in secondary microprocessor connector Install a terminator card or microprocessor in the secondary microprocessor connector. See Chapter 8, "Installing System Board Options," for instructions. NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list that precedes the Index. 3-6 Dell PowerEdge 2300 Systems Installation and Troubleshooting Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
3-6
Dell PowerEdge 2300 Systems Installation and Troubleshooting Guide
Memory parity
interrupt at
address
Improperly seated or
faulty DIMMs
Remove and reseat the
DIMMs. If the problem per-
sists, replace the DIMMs. See
“Installing DIMMs” and
“Removing DIMMs” in
Chapter 8.
Memory tests
terminated by
keystroke
POST memory test ter-
minated by pressing
<Spacebar>
No action is required.
No boot device
available
Faulty diskette, diskette/
tape drive subsystem,
hard-disk drive, hard-
disk drive subsystem, or
no boot disk in drive A
Replace the diskette or hard-
disk drive. If the problem
persists, replace the system
board. See Chapter 11, “Get-
ting Help,” for instructions on
obtaining technical assistance.
No boot sector
on hard-disk
drive
Incorrect configuration
settings in System Setup
program, or no operating
system on hard-disk
drive
Check the hard-disk drive con-
figuration settings in the
System Setup program. See
Chapter 4, “Using the System
Setup Program,” in the
Dell
PowerEdge 2300 Systems
User’s Guide
for instructions.
No timer tick
interrupt
Defective system board
Replace the system board.
See Chapter 11, “Getting
Help,” for instructions on
obtaining technical assistance.
Non-system
disk or disk
error
Faulty diskette, diskette/
tape drive subsystem, or
hard-disk drive sub-
system
Replace the diskette or hard-
disk drive. If the problem
persists, replace the system
board. See Chapter 11, “Get-
ting Help,” for instructions on
obtaining technical assistance.
Not a boot
diskette
No operating system on
diskette
Use a bootable diskette.
Processor or
terminator
card not
installed!
No microprocessor or
terminator card installed
in secondary micro-
processor connector
Install a terminator card or
microprocessor in the second-
ary microprocessor
connector. See Chapter 8,
“Installing System Board
Options,” for instructions.
7DEOH±¸¶´µ±±6\VWHP±0HVVDJHV
±²FRQWLQXHG³
0HVVDJH
&DXVH
&RUUHFWLYH²$FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and
acronym list that precedes the Index.