Edimax ER-1088 Available from Edimax USA Manual - Page 13
Basic Setup
View all Edimax ER-1088 Available from Edimax USA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
2: Basic Setup Overview Basic Setup of your Multi-WAN VPN Link Balancer involves the following steps: 1. Attach the Multi-WAN VPN Link Balancer to a PC using any LAN port (3 to16) and configure it for your LAN. 2. Install your Multi-WAN VPN Link Balancer in your LAN and connect the Broadband Modem(s). 3. Configure your Multi-WAN VPN Link Balancer for Internet Access. 4. Configure PCs on your LAN to use the Multi-WAN VPN Link Balancer. Requirements • One (1) up to eight (8) DSL or Cable modems, each with an ISP Internet Access account. • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors • TCP/IP network protocol must be installed on all PCs. Procedure 1: Configuring the Multi-WAN VPN Link Balancer for your LAN 1. Use a standard LAN cable to connect your PC to any LAN port (3 -16) on the Multi-WAN VPN Link Balancer. (Default is 2 WAN ports from Port 1 - 2) 2. Connect the power cord into the power outlet on the rear panel of the Multi-WAN VPN Link Balancer. 3. Power-on your PC. If your PC is already running, restart it. It will then obtain an IP address from the Multi-WAN VPN Link Balancer. 4. Open your WEB browser. 5. In the Address or Location box enter: HTTP://192.168.1.1 6. You will be prompted for the User Name and password, as shown below: Figure 2-1: Password Dialog Page 9