Edimax ER-1088 Available from Edimax USA Manual - Page 34
Settings - Routing
View all Edimax ER-1088 Available from Edimax USA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Figure 4-2: Routing Note: If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries. You cannot modify or delete these entries. Settings - Routing Dynamic Routing • RIP v2 - This acts as a "master" switch. If enabled, the selected WAN or LAN will run RIPv1/v2, otherwise RIP function will not be available. • Interface - If LAN or other WAN are enabled, the specified WAN or LAN can execute RIP function. Page 30
Figure 4-2: Routing
Note:
If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries.
You cannot modify or delete these entries.
Settings – Routing
Dynamic
Routing
•
RIP v2
– This acts as a “master” switch. If enabled, the selected WAN or LAN
will run RIPv1/v2, otherwise RIP function will not be available.
•
Interface
– If
LAN or
other
WAN are enabled, the specified WAN or LAN can
execute RIP function.
Page 30