Epson PictureMate Using PictureMate Without a Computer - Page 37

Insert the New Photo Cartridge, Slide the cartridge straight into the slot, label side - ink cartridge

Page 37 highlights

6 Carefully pull out the cartridge and dispose of it properly. (For appropriate disposal, check local resources for recycling guidelines.) Insert the New Photo Cartridge 1 Shake the cartridge four or five times while it is still in its package. Then unwrap the cartridge. Warning: Keep ink cartridges out of the reach of children and do not drink the ink. If ink gets on your hands, wash them thoroughly with soap and water. If ink gets in your eyes, flush them thoroughly with water. If discomfort or vision problems continue after flushing, see a doctor immediately. Caution: Don't touch the green circuit board. Install the photo cartridge immediately after you remove it from its package. If you leave a cartridge unpacked for a long time before using it, normal printing may not be possible. 2 Make sure the lever is in the Release position. 3 Slide the cartridge straight into the slot, label side up, until it is fully inserted. Push in both sides evenly to make sure it is not crooked. 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68

35
6
Carefully pull out the cartridge and dispose of it
properly. (For appropriate disposal, check local
resources for recycling guidelines.)
Warning:
Keep ink cartridges out of the reach of children and do
not drink the ink.
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them thoroughly with water.
If discomfort or vision problems continue after flushing, see a
doctor immediately.
Insert the New Photo Cartridge
1
Shake the cartridge four or five times while it is
still in its package. Then unwrap the cartridge.
Caution:
Don’t touch the green circuit board. Install the
photo cartridge immediately after you remove it from its
package. If you leave a cartridge unpacked for a long time
before using it, normal printing may not be possible.
2
Make sure the lever is in the
Release
position.
3
Slide the cartridge straight into the slot, label side
up, until it is fully inserted. Push in both sides
evenly to make sure it is not crooked.