Fisher and Paykel RDV3-304-N User Guide Dual Fuel Cooker - Page 69

TROUBLESHOOTING Cooktop burners PROBLEM The ignitor keeps clicking (continuous spark) even when a burner has lit. None of the burners will light. POSSIBLE CAUSES Dirty or wet ignitor(s) No power supply No gas supply Some burners will not light - Flames do not burn all around the burner cap. Burner parts or ignitors may be wet, dirty, or misaligned There is no clicking when I The ignitor is dirty or there is a try to light a burner power outage There is a slight 'extinction pop' or flash after I've turned a burner off. This is normal for LP gas and requires no action. The flames have suddenly gone out. A draft or a spill has extinguished the flame The burner flames are uneven, very large, yellow or yellow-tipped or sooty. There is a power failure - can I still use the cooktop burners? Technical fault: the gas is the wrong type or hasn't been adjusted properly The cooktop burners can still be used. WHAT TO DO Clean the ignitor(s). See 'Care and cleaning' for instructions. Check that there is no power outage in your area and that the power supply to the range is switched on at the circuit breaker panel. Check that the gas supply to the house is working. You should hear the gas when you turn a burner on. If you are using bottled gas, check that it is not empty. Check that the burner parts are clean, dry, and correctly assembled. Ensure the ignitors are clean and dry. See 'Care and cleaning' for instructions. Clean the ignitor(s). See 'Care and cleaning' for instructions. No action required. The burner will detect this and automatically relight. However, if there has been a large spill, we recommend turning the burners off and cleaning the burners and sump area. See 'Care and cleaning' for instrucions. Do not use your cooktop burners. Contact your Authorized Service Center or Customer Care. If the flame is blown out during a power failure, turn the dial to OFF, as the burner will not automatically relight and gas may escape. 69