GE PGS968SEPSS Use and Care Manual - Page 36

Cleaning the glass cooktop. Control Lockout Begin by locking the cooktop; see the Control Lockout section. Clean your cooktop after each spill. Use CERAMA BRYTE® Ceramic Cooktop Cleaner.* Use a CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops.* Normal Daily Use Cleaning ONLY use CERAMA BRYTE® Ceramic Cooktop Cleaner* on the glass cooktop. Other creams may not be as effective. To maintain and protect the surface of your glass cooktop, follow these steps: Before using the cooktop for the first time, clean it with CERAMA BRYTE® Ceramic Cooktop Cleaner.* This helps protect the top and makes cleanup easier. Daily use of CERAMA BRYTE® Ceramic Cooktop Cleaner* will help keep the cooktop looking new. Remove the burner grates and vent grille. Shake the cleaning cream well. Apply a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner* directly to the cooktop. Use a paper towel or CERAMA BRYTE® cleaning pad for Ceramic Cooktops* to clean the entire cooktop surface. Use a dry cloth or paper towel to remove all cleaning residue. No need to rinse. NOTE: It is very important that you DO NOT heat the cooktop until it has been cleaned thoroughly. Burned-On Residue CAUTION: DAMAGE to your glass surface may occur if you use scrub pads other than the pad included with your cooktop. Allow the cooktop to cool. Remove the burner grates and vent grille. Spread a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner* on the entire burned residue area. Using a CERAMA BRYTE® cleaning pad for Ceramic Cooktops*, rub the residue area, applying pressure as needed. If any residue remains, repeat the steps listed above as needed. For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner* and a paper towel. The CERAMA BRYTE® Ceramic Cooktop Scraper* and all recommended supplies are available through our Parts Center. See instructions under "To Order Parts" section on next page. NOTE: Do not use a dull or nicked blade. Heavy, Burned-On Residue Allow the cooktop to cool. Remove the burner grates and vent grille. Use a single-edge razor blade scraper at approximately a 45° angle against the glass surface and scrape the soil. It will be necessary to apply pressure to the razor scraper in order to remove the residue. After scraping with the razor scraper, spread a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner* on the entire burned residue area. Use a CERAMA BRYTE® cleaning pad for Ceramic Cooktops* to remove any remaining residue. For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner* and a paper towel. *For Canadian models, use a Mabe-approved equivalent when CERAMA BRYTE® products are not available. Contact Mabe Replacement Parts to order replacement cleaning products. 36