HP 8/8 Fabric OS Encryption Administrator's Guide v6.4.0 (53-1001864-01, June - Page 149
Configuring a tape LUN, LUNs. Refer
View all HP 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Crypto LUN configuration 3 TABLE 6 LUN parameters and policies (Continued) Policy name Command parameters Description Re-key policy Disk LUN: yes Tape LUN: No Modify? Yes Key lifespan Disk LUN: No Tape LUN: Yes Modify? Disks only. Tape: No -enable_rekey time_period | -disable_rekey -key_lifespan time_in_days | none Enables or disables the auto re-keying feature on a specified disk LUN. This policy is not valid for tape LUNs. By Default, the automatic re-key feature is disabled. Enabling automatic re-keying is valid only if the LUN policy is set to -encrypt. You must specify a time period in days when enabling Auto Re-keying to indicate the interval at which automatic re-keying should take place. Specifies the life span of the encryption key in days. The key will expire after the specified number of days. Accepted values are integers from 1 to 2982616. The default value is none, which means the key does not expire. On tape LUNs, the key life span cannot be modified after it is set. Configuring a tape LUN This example shows how to configure a tape storage device. The basic setup procedure is the same as for disk devices. Only a subset of configuration options and policy settings are available for tape LUNs. Refer to Table 6 on page 130 for tape LUN configuration options. 1. Create a zone that includes the initiator (host) and the target port. Refer to the section "Creating an initiator - target zone" on page 118 for instructions. 2. Create a CryptoTarget container of type tape. Refer to the section "Creating a CryptoTarget container" on page 123 for instructions. a. Create the container, allowing the encryption format to default to Native. FabricAdmin:switch>cryptocfg --create -container tape my_tape_tgt \ 10:00:00:05:1e:41:9a:7e 20:0c:00:06:2b:0f:72:6d 20:00:00:06:2b:0f:72:6d Operation Succeeded b. Add an initiator to the CryptoTarget container "my_tape_tgt". FabricAdmin:switch>cryptocfg --add -initiator my_tape_tgt \ 10:00:00:00:c9:2b:c9:3a 20:00:00:00:c9:2b:c9:3a Operation Succeeded c. Commit the transaction. FabricAdmin:switch>cryptocfg --commit Operation Succeeded 3. Configure the Crypto tape LUN. Refer to the section "Configuring a Crypto LUN" on page 128 for instructions. a. Discover the LUN. FabricAdmin:switch>cryptocfg --discoverLUN my_tape_tgt Container name: my_tape_tgt Number of LUN(s): 1 Host: 10:00:00:00:c9:2b:c9:3a LUN number: 0x0 LUN serial number: Key ID state: Key ID not Applicable b. Add the LUN to the tape CryptoTarget container. The following example enables the LUN for encryption. There is a maximum of eight tape LUNs per Initiator in a container. FabricAdmin:switch>cryptocfg --add -LUN my_tape_tgt 0x0 \ Fabric OS Encryption Administrator's Guide 131 53-1001864-01