HP AD510A HP StorageWorks 1500 Modular Smart Array maintenance and service gui - Page 118

FCC (Federal Communications Commission) Class A Equipment, compliance notice, 109 Class B Equipment, compliance notice, 109 declaration of conformity, 110 modifications, 110 notice, 109 Federal Communications Commission. See FCC, 109 Fibre Channel I/O module replacing, 85 fibre channel I/O module LEDs, 27 figures LEDs controller, 23 fibre channel 1/0 module, 27 firmware cloning, 103 cloning in redundant configurations, 71 updating, 103 floor mats, dissipating, 114 G German noise declaration, 112 ground strap specifications, 114 grounding methods, 64 methods, 113 procedures, 64 straps, wearing, 114 suggested equipment for, 114 H hard drive blank, removing, 74 blank, replacing, 74 ejector levers, 75, 77 latches, 75, 77 LEDs amber, 24 recognizing, 77 reconstructing, 77 removing, 75 removing in fault-tolerant systems, 75 securing, 77 hard drive firmware updating, 107 hazardous conditions symbols on equipment, 65 heel straps, using, 114 help obtaining, 11 hot-pluggable parts, MSA, 69 HP address for FCC questions, 110 series number, 110 technical support, 11 telephone number FCC questions, 110 I IEC EMC, worldwide regulatory compliance notice, 110 illustrated parts breakdown, 13 indicators fan module, 28 informational messages array controller restarting, 53 array controller temperature ok, 53 beacon off, 53 beacon on , 52 cache batteries low, recharging, 46 cache disabled no configuration, 46 cache hardware enabled, 45 cache hardware temporarily disabled, 46 cache module # MB, 45 configured volumes, 51 EMU flash done, 55 EMU flash started, 55 fibre subsystem link ok, 58 firmware flash done, 55 firmware flash done on box #, 55 firmware flash started, 55 firmware flash started on box #, 55 firmware version, 37 hard drive hot added box bay, 48 hard drive hot removed box bay, 48 hard drive position change detected, 48 hard drive position charge invalid, 48 initializing fibre subsystem, 57 initializing PCI subsystem, 57 initializing redundancy support, 41 initializing SCSI subsystem, 39 initializing subsystem, 39 MSA1000 active controller, 44 MSA1000 standby controller, 44 new volume(s) detected, 51 no volumes detected, 51 non-compaq hard drive, 48 obsolete cache data deleted, 46 online upgrade complete, 39 online upgrade flashing done, 39 online upgrade flashing firmware, 39 online upgrade flashing started, 39 online upgrade redundancy halted, 39 online upgrade restarting system, 39 persistent mem disabled, 59 persistent mem enabled, 59 recovery ROM autoflash done, 54 recovery ROM autoflash started, 53 redundancy active active controller, 41 118