HP AD510A HP StorageWorks 1500 Modular Smart Array maintenance and service gui - Page 57
Self Test Failure, Pci Bridge Asic
UPC - 829160218625
View all HP AD510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Message 412 STORAGE BOX # EMU NOT RESPONDING Type Error 413 STORAGE BOX # EMU VERSION Informational 414 STORAGE BOX # HOT REMOVED Informational 415 STORAGE BOX # HOT ADDED Informational 450 INVALID SCSI CABLING BOX # Error 500 INITIALIZING PCI SUBSYSTEM Informational 501 PCI SUBSYSTEM HARDWARE FAILURE Error 502 PCI BRIDGE ASIC Error SELF TEST FAILURE 510 INITIALIZING FIBRE CHANNEL SUBSYSTEM Informational Description Action An EMU in the specified storage enclosure is not responding to commands. Make sure the storage box is powered on. Ensure all cables are connected securely. Power off the MSA and the storage enclosure. Then reapply power to the storage box and then the MSA. Should the issue persist, contact HP support. The version of firmware running on the EMU. This is only displayed for the internal EMU of the MSA chassis. It is not displayed for externally connected storage boxes. An external storage enclosure has been hot-removed from the back of the MSA. An external storage enclosure has been hot-added to the back of the MSA. The MSA has detected an external storage enclosure that is cabled incorrectly. Verify that the external storage enclosures are connected properly to the MSA. For more information, see the MSA installation guide. The array controller's PCI subsystem is being initialized as part of the power-up sequence. The array controller's PCI subsystem has encountered a critical error during the power-up sequence. Remove the failed array controller, wait 10 seconds, and then reinsert the array controller, ensuring that it is fully seated in the chassis. Should the issue persist, contact HP support. The array controller's PCI bridge ASIC has encountered a critical error during the power-up sequence. Remove the failed array controller, wait 10 seconds, and then reinsert the array controller, ensuring that it is fully seated in the chassis. Should the issue persist, contact HP support. The array controller's Fibre Channel subsystem is being initialized as part of the power-up sequence. maintenance and service guide 57