HP AD510A HP StorageWorks 1500 Modular Smart Array maintenance and service gui - Page 74
Removing or installing a hard drive blank, Before you begin
UPC - 829160218625
View all HP AD510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Removing or installing a hard drive blank Before you begin CAUTION: • Before removing a component or blanking panel from an operational device, make sure that you have the replacement part available. Removing a component or blank impacts the airflow and cooling ability of the device. To avoid possible overheating, insert the new or replacement component within one or two minutes. If the internal temperature exceeds acceptable limits, the device may overheat and automatically shut down or restart. • Parts can be damaged by electrostatic discharge. Use proper anti-static protection. Removing a hard drive blank CAUTION: A blank or a hard drive must be installed in each hard drive slot. Failure to install a blank or hard drive in all slots could result in thermal failures. 1. Review all warnings, cautions, and preparation procedures as detailed in Warnings and precautions. 2. Push in the tabs to unlock the hard drive blank (1). 3. Continue to press the tabs while pulling the hard drive blank out of the chassis (2). 2 1 1 15597 Installing a hard drive blank Slide the blank into the enclosure chassis bay until it clicks into place. 74 Customer replaceable components