HP AD510A HP StorageWorks 1500 Modular Smart Array maintenance and service gui - Page 51
Media Exchanged, No Volumes
UPC - 829160218625
View all HP AD510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Message 112 VOLUME # REBUILD FAILURE 113 VOLUME # EXPANSION FAILURE 114 VOLUME # STATE DELETED 115 VOLUME # MEDIA EXCHANGED 120 CONFIGURED VOLUMES 121 NO VOLUMES DETECTED 122 NEW VOLUME(S) DETECTED Type Error Error Informational Informational Informational Informational Informational Description Action The rebuild operation on the configured volume has failed. If the volume is still operating in regenerative mode, remove the new SCSI hard drive that was added as a replacement for the original failed hard drive and replace it with a different new drive. The volume expansion operation on the configured volume has failed. Open the Array Configuration Utility (ACU) or MSA Command Line Interface (MSA-CLI) and use it to determine the state of the volume. If the volume is still operational, it is possible to retry the operation. The configured volume has been deleted and is no longer available. Volumes are deleted by using the Array Configuration Utility (ACU) or MSA Command Line Interface (MSA-CLI). All failed hard drives of the specified volume have been replaced by good hard drives or all unplugged hard drives in the volume have been plugged back in. This message should be followed by message 02 ENABLE VOLUME ? ''=YES. See the entry for 02 ENABLE VOLUME ? ''=YES. The specified number of configured volumes was detected at power-up. No configured volumes were detected at power-up. If there are supposed to be configured volumes, power off the MSA and then all attached storage enclosures. Unplug and reinsert all SCSI hard drives ensuring they are fully seated in their bays. Check the cables connecting the MSA to any attached storage enclosures. Power on the attached enclosures and then the MSA. Configured volumes from another array controller were migrated to this array controller. The configuration information has been updated. maintenance and service guide 51