HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide - R - Page 1094

Configuring iSCSI Chapter 50 Configuring iSCSI Send documentation comments to [email protected] Figure 50-24 Edit Local Zone Database Dialog Box in Fabric Manager Step 2 Select the VSAN you want to add the iSCSI host initiator to and click OK. You see the available zones and zone sets for that VSAN (see Figure 50-25). Figure 50-25 Available Zones and Zone Sets Step 3 From the list of available devices with iSCSI host initiators, drag the initiators to add into the zone. Step 4 Click Distribute to distribute the change. iSCSI-Based Access Control iSCSI-based access control is applicable only if static iSCSI virtual targets are created (see the "Static Mapping" section on page 50-10). For a static iSCSI target, you can configure a list of iSCSI initiators that are allowed to access the targets. By default, static iSCSI virtual targets are not accessible to any iSCSI host. You must explicitly configure accessibility to allow an iSCSI virtual target to be accessed by all hosts. The initiator access list can contain one or more initiators. The iSCSI initiator can be identified by one of the following mechanisms: • iSCSI node name • IPv4 address and subnet 50-26 Cisco MDS 9000 Family Fabric Manager Configuration Guide OL-17256-03, Cisco MDS NX-OS Release 4.x