HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide - R - Page 1191

Chapter 54 Configuring IPv6 for Gigabit Ethernet Interfaces Configuring IPv6 Static Routes Send documentation comments to [email protected] Step 1 Choose IP > Routing. You see the IP Routing Configuration dialog box. (see Figure 54-11). Figure 54-12 IP Routing Configuration in Device Manager Step 2 Check the Routing Enabled check box. Step 3 Click Apply to save these changes or click Close to discard any unsaved changes. Configuring IPv4 and IPv6 Protocol Addresses When an interface in a Cisco networking device is configured with both an IPv4 and an IPv6 address, the interface can send and receive data on both IPv4 and IPv6 networks. To configure an interface in a Cisco networking device to support both the IPv4 and IPv6 protocol stacks using Device Manager, follow these steps: Step 1 Step 2 Step 3 Step 4 Click Interfaces > Gigabit Ethernet and iSCSI. You see the Gigabit Ethernet Configuration dialog box. Click the IP Address field that you want to configure and click Edit IP Address. You see the IP Address dialog box. Click Create and set the IP Address/Mask field, using the IPv4 or IPv6 format. Click Create to save these changes or click Close to discard any unsaved changes. Configuring IPv6 Static Routes Cisco MDS NX-OS supports static routes for IPv6. This section includes the following topics: • Configuring a IPv6 Static Route, page 54-13 Configuring a IPv6 Static Route You must manually configure IPv6 static routes and define an explicit path between two networking devices. IPv6 static routes are not automatically updated and must be manually reconfigured if the network topology changes. OL-17256-03, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Fabric Manager Configuration Guide 54-13