HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide - R - Page 469

Chapter 21 Configuring N Port Virtualization Configuring NPV Send documentation comments to [email protected] To select the NPV devices that need load balancing, click Configure Load Balancing, and then select the NPV devices for disruptive load balancing as shown in Figure 21-24. Figure 21-24 Select the NPV Devices for Load Balancing To set up the traffic management map, select at least one switch of version 4.1(1a) or above, a server interface, and external interfaces. To add a map entry, follow these steps: a. Click Add to create a new map row. b. Double-click the NPV Device cell and select the switch from the drop-down list. c. Double-click the Server Interface cell and then type the port numbers or click the [...] button (not available on blade server switches) in the cell to display the port selection dialog box. In the port selection dialog box, click the numbered buttons to select the ports as shown in Figure 21-25. Figure 21-25 Select the Interfaces Note You can select only one Server If port in a row, but multiple External IF ports can be mapped to it. Previously selected ports are disabled and cannot be selected. d. Double-click the External Interfaces cell and type the port numbers or click the [...] button (not available on blade server switches) in the cell to display the port selection dialog box. In the port selection dialog box, click the numbered buttons to select the ports as shown in Figure 21-25. To delete an exsiting map entry, select the row, and then click Delete. To delete all the existing map entries, click Delete All. OL-17256-03, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Fabric Manager Configuration Guide 21-27