HP Cisco MDS 9120 Cisco MDS 9000 Family Fabric Manager Configuration Guide - R - Page 403

Chapter 19 Managing Modules Identifying Module LEDs Send documentation comments to [email protected] Step 3 Step 4 Step 5 Click the Card Module Config tab. Select off from the drop-down list in the row for the module(s) you want to power off. Click the Apply Changes icon. Note To power on a module, repeat Steps 1-4 but select on in Step 3. Identifying Module LEDs Table 19-5 describes the LEDs for the Cisco MDS 9200 Series integrated supervisor modules. Table 19-5 LEDs for the Cisco MDS 9200 Series Supervisor Modules LED Status Speed Link Status Description Green All diagnostics pass. The module is operational (normal initialization sequence). Orange One of the following applies: The module is booting or running diagnostics (normal initialization sequence). The inlet air temperature of the system has exceeded the maximum system operating temperature limit (a minor environmental warning). To ensure maximum product life, you should immediately correct the environmental temperature and restore the system to normal operation. Red One of the following applies: The diagnostic test failed. The module is not operational because a fault occurred during the initialization sequence. The inlet air temperature of the system has exceeded the safe operating temperature limits of the card (a major environmental warning). The card has been shut down to prevent permanent damage. The system will be shut down after two minutes if this condition is not cleared. On 2-Gbps mode and beacon mode disabled. Off 1-Gbps mode and beacon mode disabled. Flashing Beacon mode enabledSee the "Identifying the Beacon LEDs" section on page 20-19. Solid green Link is up. Solid yellow Link is disabled by software. Flashing A fault condition exists. yellow Off No link. OL-17256-03, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Fabric Manager Configuration Guide 19-9