HP J3111A HP JetDirect 600N Print Server Hardware Installation Guide - 5969-68 - Page 23

For HP J3113A 10/100Base-TX cards, For LocalTalk-Only Customers, Installing the Print Server 2-9

Get HP J3111A - JetDirect 600N Network Card PDF manuals and user guides
UPC - 002421211157
View all HP J3111A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Figure 2-3 Example of HP JetDirect Configuration Page I/O CARD READY Installing the 2 Print Server 3. If I/O CARD READY appears, the card has been installed successfully. Proceed to "Step 6. Configure the Card for Network Operation." 4. If I/O CARD READY does not appear, check that you have: I Installed the card correctly and properly connected the card to the network I Verified that the network is operating properly I Turned the printer off and then on again Note For HP J3113A 10/100Base-TX cards: See appendix A in this guide for special troubleshooting information. For LocalTalk-Only Customers: If you are not connected to an Ethernet network, "I/O CARD NOT READY" and "LAN ERROR - EXTERNAL LOOPBACK" messages may appear. These messages should stop appearing after three minutes. To eliminate the messages, attach an Ethernet loopback connector to one of the Ethernet ports. Installing the Print Server 2-9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
Installing the Print Server 2-9
Installing the
Print Server
2
Figure 2-3
Example of HP JetDirect Configuration Page
3.
If I/O CARD READY appears, the card has been installed
successfully. Proceed to
“
Step 6
.
Configure the Card for Network
Operation
.
”
4.
If I/O CARD READY does not appear, check that you have:
■
Installed the card correctly and properly connected the card
to the network
■
Verified that the network is operating properly
■
Turned the printer off and then on again
Note
For HP J3113A 10/100Base-TX cards:
See
appendix
A
in this guide for special troubleshooting
information.
For LocalTalk-Only Customers:
If you are
not connected to an Ethernet network,
“
I/O CARD
NOT READY
”
and
“
LAN ERROR - EXTERNAL
LOOPBACK
”
messages may appear. These
messages should stop appearing after three
minutes. To eliminate the messages, attach
an Ethernet loopback connector to one of the
Ethernet ports.
I/O CARD READY