HP J3111A HP JetDirect 600N Print Server Hardware Installation Guide - 5969-68 - Page 43

HP J3113A 10/100Base-TX Print Server, Supported Links, Link-Speed LEDs

Get HP J3111A - JetDirect 600N Network Card PDF manuals and user guides
UPC - 002421211157
View all HP J3111A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

A HP J3113A 10/100Base-TX Print Server Supported Links HP J3113A 10/100 Base-TX print servers support 10 or 100 Mbps operation using full-duplex or half-duplex transmission channels. When connecting to network devices that do not support autonegotiation, the print server will configure itself for 10-Mbps or 100-Mbps half-duplex operation. For example, when connected to a non-negotiating 10 Mbps hub, the print server card will automatically set itself to operate at 10-Mbps half-duplex. If the card is not able to connect to the network through autonegotiation, you can manually set the link operating mode using link configuration jumpers (P1, P2, and P3) on the card. Link-Speed LEDs The HP J3113A print server provides 2 light-emitting diodes (LEDs) near the RJ-45 connector. These LEDs indicate the operating link speed of the print server. LED State Description Off Not linked On Link established at either 10 Mbps or 100 Mbps LEDs HP J3113A 10/100Base-TX Print Server A-1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
HP J3113A 10/100Base-TX Print Server A-1
A
HP J3113A 10/100Base-TX Print
Server
Supported Links
HP J3113A 10/100 Base-TX print servers support 10 or 100 Mbps
operation using full-duplex or half-duplex transmission channels.
When connecting to network devices that do not support
autonegotiation, the print server will configure itself for
10-Mbps
or
100-Mbps half-duplex
operation. For example, when connected
to a non-negotiating 10 Mbps hub, the print server card will
automatically set itself to operate at
10-Mbps half-duplex
.
If the card is not able to connect to the network through
autonegotiation, you can manually set the link operating mode
using
link configuration jumpers (P1, P2, and P3)
on the card.
Link-Speed LEDs
The HP J3113A print server provides 2 light-emitting diodes
(LEDs) near the RJ-45 connector. These LEDs indicate the
operating link speed of the print server.
LED State
Description
Off
Not linked
On
Link established
at either 10 Mbps
or 100 Mbps
LEDs