HP J3111A HP JetDirect 600N Print Server Hardware Installation Guide - 5969-68 - Page 44
Link Configuration Jumper Settings, A-2 HP J3113A 10/100Base-TX Print Server
UPC - 002421211157
View all HP J3111A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Link Configuration Jumper Settings Link configuration jumpers (P1, P2, and P3) can be used to configure the card. These jumpers should be used if the card is unable to establish a network link through autonegotiation. If P1 is changed to the AUTO=OFF position, then P2 selects the link speed (10 or 100 Mbps) and P3 selects the communication mode (Half duplex or Full duplex). If you manually configure the card using jumpers P2 and P3, you must match the configuration of the connecting device, such as the network hub or switch. Jumper Setting Descriptions AUTO = ON (Default)* Jumper Location 100 Mbps Half-Duplex (AUTO = OFF) 100 Mbps Full-Duplex (AUTO = OFF) 10 Mbps Half-Duplex (AUTO = OFF) 10 Mbps Full-Duplex (AUTO = OFF) (*Note: If the jumper on P1 is removed or lost, the card defaults to the AUTO=ON state.) A-2 HP J3113A 10/100Base-TX Print Server