HP Pavilion zt1100 HP Pavilion Notebook PC ZT1000 Series and Omnibook Noteboo - Page 135

Reference Information Modem Reference Information Command M0 M1 M2 M3 N0 N1 O0 O1 P Q0 Q1 Sn Sn? Sn=v T V0 V1 W0 W1 W2 X0 X1 X2 X3 X4 Y0 Y1 Z0 Z1 &C0 &C1 &D0 &D1 &D2 &D3 &F0 Function (Ambit) Turn speaker off Turn speaker on during handshaking and turn speaker off while receiving carrier Turn speaker on during handshaking and while receiving carrier Turn speaker off during dialing and receiving carrier and turn speaker on during answering Turn off automode detection Turn on automode detection Go on-line Go on-line and initiate a retrain sequence Force pulse dialing Allow result codes to DTE Inhibit result codes to DTE Select S-Register n as default Return the value of S-Register n Set default S-Register n to value v Force DTMF dialing Report short form result codes Report long form result codes Report DTE speed only Report line speed, EC protocol and DTE speed Report DCE speed only Report basic call progress result codes, i.e., Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and dial tone not detected), No Answer and Error Report basic call progress result codes and connections speeds (Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and dial tone not detected), No Answer, Connect XXXX, and Error Report basic call progress result codes and connections speeds, i.e., Ok, Connect, Ring, No Carrier (also, for busy, if enabled, and dial tone not detected), No Answer, Connect XXXX, and Error Report basic call progress result codes and connections rate, i.e., Ok, Connect, Ring, No Carrier, No Answer, Connect XXXX, Busy, and Error Report all call progress result codes and connections rate, i.e., Ok, Connect, Ring, No Carrier, No Answer, Connect XXXX, Busy, No Dial Tone and Error Disable long space disconnect before on-hook Enable long space disconnect before on-hook Restore stored profile 0 after warm reset Soft reset and restore stored profile 1 after warm reset Soft reset and force RLSD active regardless of the carrier state Allow RLSD to follow the carrier state Interpret DTR On-to-OFF transition per &Qn &Q0, &Q5, &Q6: The modem ignores DTR &Q1, &Q4: The modem hangs up &Q2, &Q3: The modem hangs up Interpret DTR On-to-OFF transition per &Qn &Q0, &Q1, &Q4, &Q5, &Q6: Asynchronous escape &Q2, &Q3: The modem hangs up Interpret DTR On-to-OFF transition per &Qn &Q0 through &Q6: The modem hangs up Interpret DTR On-to-OFF transition per &Qn &Q0, &Q1, &Q4, &Q5, &Q6: Soft reset &Q2, &Q3: The modem hangs up Restore factory configuration 0 Reference Guide 135