HP ProLiant 1500 SMART-2DH Array Controller Reference Guide - Page 162

E-3 1 3 2 Figure E-1. Removing Array Accelerator Board from the SMART-2DH controller WARNING: Do not abuse, recharge, disassemble, dispose of in fire or heat above 90
C, incinerate, or expose to water or fire. Disposal of the batteries or Array Accelerator module should be accomplished within compliance of local regulations or returned to Compaq Computer Corporation by established parts return methods. Array Accelerator Installation To install the Array Accelerator board on the SMART-2DH Controller: 1. Carefully align the connectors and plug the Array Accelerator board onto the SMART-2DH Controller (1). Be sure the connectors are fully mated by squeezing the boards together at the connector side. 2. Align the plastic standoff on the Array Accelerator board with the slot in the SMART-2DH Controller board. Push it through and rotate the top of the standoff 90
to lock the board in place (2). 3. Align the plastic stabilizing bracket with the holes on both boards, ensuring that the mated boards will fit between the lips on the bracket. Push the bracket in place until the detents snap through the holes (3). SMART-2DH Array Controller Reference Guide Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002 File Name: L-APPE.DOC Last Saved On: 2/27/98 12:06 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED