HP ProLiant 1500 SMART-2DH Array Controller Reference Guide - Page 76

6-8 Installing the Operating System Drivers Using the Compaq Drive Array Optimization Utility (CPQDAOPT) Compaq recommends that you use the Compaq Drive Array Optimization Utility (CPQDAOPT.NLM) to optimize your drive arrays before creating partitions. CPQDAOPT is a utility designed to assist you in optimizing performance and can increase drive array performance by 20 to 40 percent. This is accomplished by adjusting the size of the Hot Fix Redirection Area of a partition to reduce the number of disk accesses. CPQDAOPT provides you with a formula specific to your configuration. You must use this information as you create a partition using INSTALL.NLM. If you installed NetWare/intraNetWare using SmartStart, it is not necessary to run this utility. Using CPQDAOPT On New NetWare/intraNetWare Servers Before you load CPQDAOPT on your new NetWare/intraNetWare server, make sure you have followed the instructions for installing NetWare/intraNetWare from CD found in the INSTALL.RDM file on Novell SSD Disk 1. NOTE: Back up existing data before applying new settings to data volumes. 1. Start your NetWare/intraNetWare server. 2. Copy the CLIB.NLM and STREAMS.NLM files from the NetWare/intraNetWare Installation CD-ROM (D:\NW410\BOOT or D:\INTRANETWARE.312\________\C; where the line represents eight underscores) to the server's DOS partition before you begin installation. 3. Start the NetWare/intraNetWare installation. When loading drivers, be sure that you have the CPQDA386.DSK (version 3.10 or later) or CPQARRAY.HAM driver loaded. 4. When the "Create NetWare Partition" option appears, use the Alt+Esc key sequence to change to the console prompt and load CLIB: load clib.nlm 5. Load CPQDAOPT.NLM from Novell SSD Disk 3: Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002 File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED