HP StorageWorks 4/32 HP StorageWorks DC and DC04 SAN Backbone Director Switche - Page 148
Establishing an Ethernet connection,
View all HP StorageWorks 4/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
4. Set up the CP1 IP address by entering the ipaddrset -cp 1 command: swDir:admin> ipAddrSet -cp 1 Enter the configuration information at the prompts. This is a sample IP configuration: swDir:admin> ipaddrset -sw 0 Ethernet IP Address [0.0.0.0]: 123.123.123.120 Ethernet Subnetmask [0.0.0.0]: 123.123.123.123 Fibre Channel IP Address [0.0.0.0]: Fibre Channel Subnetmask [0.0.0.0]: Issuing gratuitous ARP...Done. Committing configuration...Done. swDir:admin> ipaddrset -cp 0 Host Name [cp0]: Ethernet IP Address [10.77.77.75]: 123.123.123.121 Ethernet Subnetmask [0.0.0.0]: 123.123.123.123 Gateway IP Address [0.0.0.0]: 123.123.123.124 IP address is being changed...Done. Committing configuration...Done. swDir:admin> ipaddrset -cp 1 Host Name [cp1]: Ethernet IP Address [10.77.77.74]: 123.123.123.122 Ethernet Subnetmask [0.0.0.0]: 123.123.123.123 Gateway IP Address [0.0.0.0]: 123.123.123.124 IP address of remote CP is being changed...Done. Committing configuration...Done. swDir:admin> reboot 5. Type reboot to reboot the DC04 SAN Director. NOTE: The serial port can be used to monitor error messages through a serial connection. After using the port, remove the serial cable and replace the shipping cap on the port. Establishing an Ethernet connection NOTE: Connecting the CP blades to a private network/VLAN is recommended. After using a serial connection to configure the IP addresses for the DC04 SAN Director (see "Configuring IP addresses" on page 147), you can connect the active CP blade to the Local Area Network (LAN). By establishing an Ethernet connection, you can complete the DC04 SAN Director configuration using either a serial session, Telnet, or management applications, such as Web Tools or Fabric Manager. 148 DC04 SAN Director log in and configuration