HP Surestore Tape Library Model 6/60 SAN Solution Installation Guide - Page 38

Powering-on the 10/180 Library, Initializing the Library

Get HP Surestore Tape Library Model 6/60 PDF manuals and user guides View all HP Surestore Tape Library Model 6/60 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Figure 2-7 Installation Tape Libraries To power-on the 10/180 library, lift the switch or switches behind the rear door (see Figure 2-7). Powering-on the 10/180 Library NOTE Verify the correct firmware is installed by referring to Appendix A, Firmware Version Table. Initializing the Library Powering-on the library causes it to perform an initialization or IPL. During IPL, the library initializes the robotic components, audits any cartridges in the storage and reserved cells, and automatically verifies some configuration values, such as drive locations and drive types. 2-20 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
Installation
Tape Libraries
Chapter 2
2-20
To power-on the
10/180
library, lift the switch or switches behind the
rear door (see Figure 2-7).
Figure 2-7
Powering-on the 10/180 Library
NOTE
Verify the correct firmware is installed by referring to Appendix A,
Firmware Version Table.
Initializing the Library
Powering-on the library causes it to perform an initialization or IPL.
During IPL, the library initializes the robotic components, audits any
cartridges in the storage and reserved cells, and automatically verifies
some configuration values, such as drive locations and drive types.