HP Tc2100 hp server tc2100 installation sheet (English) - Page 43
Installing Additional Memory, Introduction, Tools Required, Memory Installation Guidelines - maximum memory
View all HP Tc2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
5 Installing Additional Memory Introduction The main memory for the HP Tower Server tc2100 is implemented using three memory slots on the system board and it supports up to 1.5 GB (512 MB x 3) of memory. The Server only supports HP 168-pin, PC 133 (133 MHz), 3.3V, buffered, ECC SDRAM DIMMs and ships with at least one 128 MB DIMM installed. The embedded video controller is provided with 4 MB standard video memory and cannot be upgraded. NOTE Use only PC 133 (133 MHz) ECC SDRAM DIMMs acquired from Hewlett-Packard. The EDO DIMMs and PC 100 SDRAM DIMMs from earlier HP Server models will fit into the DIMM slots in the HP Server tc2100, but the EDO DIMMs and PC 100 SDRAM will not function properly. To ensure you have the correct DIMMs before installation, refer to one of the following for a list of qualified DIMMs: • HP Order Assistant on the HP web site at: http://www.hp.com/ • HP Customer Service Tools Required Use an anti-static service kit (3M 8501/8502/8503 or equivalent). This kit includes a static-dissipating work surface, a chassis clip lead, and a wrist strap. Memory Installation Guidelines The HP Server tc2100 uses PC 133 (133 MHz) buffered ECC SDRAM DIMMs, which are electrically different from the EDO and PC100 SDRAM memory modules used in previous HP Server models. • DIMMs sizes supported are 128 MB, 256 MB, or 512 MB in any combination. • Supported memory capacity ranges from 128 MB to 1.5 GB maximum (512 MB x 3 DIMM slots total). The minimum capacity is 128 MB (one DIMM). 37