Hitachi DK23EA Specifications - Page 80
Max Address Command. The offset condition is cleared by Set Feature Command Subcommand 89h
View all Hitachi DK23EA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
The Set Max Unlock command changes the device from the Set Max Locked mode to the Set Max Unlocked mode. The Set Max Freeze Lock command allows the host to disable the Set Max commands (including Set Max Unlock) until the next power cycle. When this command is accepted the device is in the Set Max Frozen mode. 6.3.2.10.2 Address Offset Feature Computer systems perform initial code booting by reading from a predefined address on a disk drive. To allow an alternate bootable operating system to exist in a reserved are on disk drive, Address Offset Feature provides a Set Feature function to temporarily offset the drive address space. The offset address space wraps around so that the entire disk drive address space remains addressable in offset mode. The Set Max pointer is set to the end of the reserved area to protect the data in the user area when operating in offset mode. This protection can be removed by an Set Max Address command to move the Set Max pointer to the end of the drive. Set Feature Command Subcommand code 09h "Enable Address Offset Mode command" offsets address Cylinder 0, Head 0, Sector 1, LBA 0, to the start of a non-volatile reserved area established using the Set Max Address Command. The offset condition is cleared by Set Feature Command Subcommand 89h "Disable Address Offset Mode", Software Reset, Hardware Reset or Power on Reset. Upon entering offset mode the capacity of the drive returned in the Identify Device data is the size of the former reserved area. A subsequent Set Max Address Command using the address returned by Read Max Address Command allows access to the entire drive. Addresses wrap so the entire drive remains addressable. If a non-volatile reserved area has not been established before the device receives a Set Features Enable Address Offset Mode command, the command fails with Abort error status. Disable Address Offset Mode removes the address offset and sets the size of the drive reported by the Identify Device command back to the size specified in the last non-volatile Set Max Address command. Identify Device Word 83 bit 7.indicates the device supports the Set Features Address Offset Mode. Identify Device Word 86 bit 7 indicates the device is in address offset mode. K6602637 Rev.3 02.27.01 - 80 -