Hitachi L42S504 Owners Guide - Page 6

Accessories Check to make sure you have the following accessories before disposing of the packing material. Remote Control Unit CLU-4997S (Part No. HL02567) "AAA" Size Batteries (2) Power Cord Owners Guide ® Series LCD Flat Panel HDTV Easy Graphic Guide Stand Screws (4) 32" (T4x12: Part No. Q1G940-12-47) Thank you for purchasing this Hitachi product. Please read these instructions carefully. For additional assistance please call 800.Hitachi (800.448.2244) or visit our website at www.hitachi.us/tv. Keep this owners guide for future reference. Record the model name and serial number of your LCD Television for future reference. This information is located on the back and right side of the television. MODEL NAME SERIAL NO TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 2-4 FIRST TIME USE ...5-17 THE REMOTE CONTROL 18-27 ON-SCREEN DISPLAY ...28-41 USEFUL INFORMATION ...42-48 LIMITED WARRANTY ...49 END USER LICENSE AGREEMENT FOR HITACHI DTV SOFTWARE 50-54 APPENDIXES ...55 INDEX ...56 HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. Revision 020310 42" (M6x12: Part No. OM1G1760 12225 CR3) Stand Base 32" (Part No. A34T1051 & A15T0643) 42" (Part No. A34T0982-11-01 & A15T0646-101) For optional accessories, please access our web site at: www.hitachi.us/tv CAUTION • Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front panel. This LCD television product is designed for a maximum tilting angle of 45 degrees from vertical. • Please see page 8 for important information related to wall mounting. REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT The remote control operates on 2 "AAA" batteries. 1. Open the battery cover of the remote control by pushing and pulling it in the direction of the arrow. 2. Insert two new "AAA" size batteries for the Remote Control. When replacing old batteries, push them towards the springs and lift them out. 3. Match the batteries to the (+) and (-) marks in the battery compartment. 4. Insert the bottom of the battery, the (-) side, into the battery compartment first, push towards the springs and insert the top of the battery, the (+) side, into place. Do not force the battery into the battery compartment. 5. C lose the battery cover making sure the tabs rest in the corresponding holes and push down the cover until it clicks shut. CAUTION • Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries to swell or rupture resulting in leakage. • Never mix used and new batteries in the device. • Replace all the batteries in the device at the same time. • Remove the batteries if the remote control is not going to be used for an extended period of time. • The batteries (batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. 6