Hotpoint RGB528PENBB Owners Manual - Page 21

ge.com Grid Broiler Pan and Grid Mter broiling, reinove tile broiler pan fl'oin tile oven. Ren/ove tile grid fl'onl tile pan. Tile broiler pan and grid nlay be cleaned with a ('oi//illercial oxen cleanei: (:aI'efully po/li" otlt grease fl'onl tile pan I I I into a proper containei: _\'ash and rinse Both tile broiler pan and grid can also be cleaned in a dishwashei: I tile broiler pan and grid in hot water with a soap-filled or plastic scouting pad. Do not store a soiled broiler pan and grid If tood has burned oil, spiin!de tile grid with deteigent while hot and cover with wet paper towels or a dishcloth. Soaking tile pan will reniove burned-on fi)ods. anywhere in the range, A CAUTIOND: oncole, an,heb oile pan or grid in a self-cleaning oven. Removable Broiler Drawer (on some models) Toremove: To replace: [] XAq/eIl tile broiler is cool, renlove tile grid and pan. [] Pull tile broiler drawer ()tit until it stops, then push it back in about one inch. Hold tile broiler drawer in tile raised position as you slide it partway into tile range. Then lower tile drawer and push it conipletely closed. [] (;rasp tile handle, lift and pull tile broiler drawer ()/it. Clean tile broiler drawer with hot soap) watei: Ventappearance and location var,A OvenAir Vents Never block tile vents (air openings) of the range. Tile}' provide tile air inlet and outlet that are necessai_' fl)r tile range to operate properly with correct conlbustion. Air openings are located at tile rear of tile cooktop, at tile top and bottoIn of tile oven dooI, and at tile bottoIn of tile range, under tile kick panel or broiler drawer (depending oil tile nlodel). !iiiii_iiii_Jiiiiiiiii =: Puffthe knobstraightoff the stem. Lower Control Panel (Front Manifold Panel) and Knobs It's a good idea to wipe tile ci)ntrol panel after each use of tile oven. Use a danip cloth to clean or rinse. For cleaning, use nfild soap and water or a 50/50 sohition of vinegar and wateI: For Iinsing, use clean watei: Polish di_' with a soft cloth. Do not use abrasive cleansei_, strong liquid cleanei_, plastic scouiing pads or ()veil cleanei_ on tile control they will danlage tile finish. panel-- Do not bend knobs by pulling theIn up or down or by hanging a towel or other such loads. This can daniage the gas wflve shall Tile control knobs niav be renloved fl)r easier cleaning, Make sure the knobs are in the OFF positions and pull theIn straight off tile stenIs fi)r cleaning. Tile knobs can be cleaned in a dishwasher or they nlay also be washed with soap and wateI: Make sure file insides ot the knobs are (li T before replacing. Replace the knobs in the OFFposition to ensure proper placenient. Metal parts can be cleaned with soap and wateI: Do not use steel wool, abI'asives, _lIllI/lOIli_l, acids or coilli/lei'cial ()veil cleaneis. Dry with a soft cloth. g g } 2/