IBM 8649 Hardware Maintenance Manual - Page 127
checkout, built-in, fault, messages
UPC - 000435133427
View all IBM 8649 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Note: See "System replaceable units" on page 122 to determine which components should be replaced by a field service technician. Message Action System shutoff due to CPU x under temperature (level-critical; CPU x is under temperature) Ambient temperature must be within normal operating specifications; see "Features and specifications" on page 3 System shutoff due to DASD temperature (sensor x) (level-critical; DASD area reported temperature outside recommended operating range) Ensure that the system is being properly cooled; see "System reliability considerations" on page 33 System shutoff due to high ambient temperature (level-critical; high ambient temperature) Ambient temperature must be within normal operating specifications; see "Features and specifications" on page 3 System shutoff due to system board under temperature (level-critical; system board is under temperature) Ambient temperature must be within normal operating specifications; see "Features and specifications" on page 3 DASD checkout Note: See "System replaceable units" on page 122 to determine which components should be replaced by a field service technician. Message Action Hard drive x removal detected (level-critical; hard drive x has been removed) Information only; take action as appropriate. Host built-in self test (BIST) Note: See "System replaceable units" on page 122 to determine which components should be replaced by a field service technician. Message Action Host fail (level-informational; built-in self-test for the host failed) 1. Reseat the microprocessor. 2. Replace the microprocessor. Bus fault messages Note: See "System replaceable units" on page 122 to determine which components should be replaced by a field service technician. Bus fault messages Message Action Failure reading 12C device. Check devices on bus 0. 1. If installed, reseat the I2C cable between Remote Supervisor Adapter (in PCI slot 1/J14) and the Remote Supervisor Adapter connector on the system board. 2. Memory DIMMs. 3. System board. Chapter 6. Symptom-to-FRU index 117