IBM 8649 Hardware Maintenance Manual - Page 47
Removing, bezel
UPC - 000435133427
View all IBM 8649 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Removing the bezel When working with some devices, such as additional optical drives, you must first remove the bezel to access the device. Complete the following steps to remove the bezel: 1. Remove the side cover ("Removing the bezel"). 2. For hot-swap hard disk drive models: a. Open the server door. b. Rotate the hot-swap lock bar forward and remove it from the bezel (see the illustration on page 47). If the hot-swap lock bar will not rotate, press the top of the hot-swap lock bar to release the lock mechanism. 3. Locate the bezel-release lever; then, press the bezel-release lever toward the front of the server. 4. Pull the top of the bezel away from the chassis; then, push the bezel down to disengage the bottom tabs. 5. Remove the bezel from the server and store the bezel in a safe place. For instructions for replacing the bezel, see "Replacing the bezel" on page 66. Chapter 4. Installing options 37