IBM 867282X Maintenance Manual - Page 60
cable connectors, on for the location of the microprocessor
UPC - 087944650966
View all IBM 867282X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
v Microprocessor connector Microprocessor Heat sink Heat sink retainer Microprocessor orientation indicator Lever a. Peel the plastic protective strip off the bottom of the heat sink. Make sure the square of thermal material is still on the bottom of the heat sink; if not, replace the it with a new heat sink. b. Align and place the heat sink on top of the microprocessor. c. Align and push the heat-sink retainer through the groove in the center of the fan sink. d. Insert a small, flat-bladed screwdriver into the tab on the heat-sink retainer. e. Press the screwdriver down to snap the heat-sink retainer into place. f. Connect the heat-sink power cable to the microprocessor heat-sink connector (CPUFA1) on the system board. See "System board internal cable connectors" on page 40 for the location of the microprocessor heat-sink connector. 6. If you have other options to install or remove, do so now; otherwise, replace the cover. See "Installing the cover" on page 53 for instructions on installing the cover. 7. Reconnect the external cables and power cords; then, turn on the peripheral devices and the server. 52 Hardware Maintenance Manual: xSeries 300