Insignia NS-LCD22 User Manual (English) - Page 22

NS-LCD22.fm Page 20 Monday, February 19, 2007 1:39 PM Category Problem Possible Solution Television cabinet creaks Control buttons do not operate • When the television is in use, there is a natural rise in temperature, causing the cabinet to expand or contract and may be accompanied by a slight creaking noise. This is not a malfunction. • Disconnect the power cord and wait for a few seconds. Then re-connect the power cord and turn on the television again. Caution Never attempt to repair a defective television yourself. Note If your problem is not solved, turn your television off and then on again. Specifications Note • • • Design and specifications are subject to change without notice. Weight and dimensions shown are approximate. Specifications and external appearance may be changed for the sake of improvement. Type LCD TV Panel 22-inch TFT LCD TV system American TV standard ATSC/NTSC system Receiving channels VHF 2-13, UHF 14-69, CATV 1-125, CADTV 1-135, DTV 2-69 Audio multiplex BTSC system Audio out 4W x 2 Power requirement AC 100-240 V. 50/60 Hz Power consumption 60 W Dimensions 23.2 x 19.2 x 7.1-inches (589 x 487 x 180 mm) Weight 24 lbs/11 kg Input terminals 1 Composite Video/Audio (L/R) 1 S-video 1 Component Video/Audio (L/R) 1 HDMI interface 1 VGA/Audio 1 Antenna Output terminals 1 Composite Video/Audio (L/R) 1 headphone jack Control terminals 1 RS-232 Insignia NS-LCD22 LCD TV Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment. DHHS and FDA safety certification This product is made and tested to meet safety standards of the FCC, requirements and compliance with safety performance of the U.S. Department of Health and Human Services, and also with FDA Radiation Performance Standards 21 CFR Subchapter J. Canada ICES-003 statement This Class B digital apparatus complies with Canadian ICES-003. RSS 310 statement To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. Copyright © 2007 Insignia. Insignia and the Insignia logo are trademarks of Best Buy Enterprise Services, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. Specifications and features are subject to change without notice or obligation. For service and support call (877) 467-4289. 20 www.insignia-products.com