Intel SC5600BASE Service Guide - Page 33
Installing the Air Duct
View all Intel SC5600BASE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Hardware Installations and Upgrades 4. Unlatch the air duct from the chassis by pressing the tab at the rear of the air duct located on the rear system fan bracket (See letter "A"). 5. Grasp the air duct and remove (see letter "B"). Figure 12. Removing the Air Duct Installing the Air Duct Installing the Air Duct in Intel® Server Chassis SC5600Base and SC5600BRP 1. If your system has two processors, remove the inner plastic inlet filler board from the inside of the air duct (see the following figure for inlet filler board removal details). CAUTION This step only applies to systems with two processors. If your server board has only one processor installed, leave the inner air baffle in place and proceed to Step 2. 2. Install the air duct. Make sure aligning the air duct and chassis rear fan bracket (see letter "D" in Figure 13) alignment rails (see letter "C" in Figure 13) before inserting air duct tabs (see letter "B" in Figure 13) into the chassis rear fan bracket slots (see letter "A" in Figure 13). Intel® Server Chassis SC5600 Service Guide 19