Invacare M91 Owners Manual - Page 43
Adjusting the Footboard Assembly
View all Invacare M91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Mounting Hole Wheelchair Frame SECTION 8-FOOTBOARD ASSEMBLY Quick Release Pin DETAIL "A" - BOTTOM VIEW OF FOOTBOARD Quick Release Pin Detent Ball Footboard Assembly Outer Edge of Tube Detent Balls FIGURE 8.1 Removing/Installing the Footboard Assembly Adjusting the Footboard Assembly Angle NOTE: For this procedure, refer to FIGURE 8.2. 1. Loosen the jam nut and set screw located underneath on the back of the footplate. 2. Adjust the set screw in or out to obtain the desired footboard assembly angle. 3. Thread the jam nut and washer inward until it is flush with the footboard bracket. 4. Securely tighten the jam nut and washer to secure the mounting screw in place. Set Screw, Washer and Jam Nut Footboard Assembly FIGURE 8.2 Adjusting the Footboard Assembly - Angle Part No 1141450 43 Pronto® M91™ with SureStep®