Invacare M91 Owners Manual - Page 53

SECTION 9-FRONT RIGGINGS Installing/Removing Elevating Legrests NOTE: For this procedure, refer to FIGURE 9.13. Installing 1. Turn legrest to side (open footplate is perpendicular to wheelchair). 2. Install the legrest hinge plates onto the hinge pins on the wheelchair frame. 3. Rotate legrest toward the inside of the wheelchair until it locks in place. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 4. Repeat STEPS 1‐3 for the opposite legrest. 5. After the user is seated in wheelchair, adjust footplate to correct height by loosening nut and sliding the lower footrest assembly up or down until desired height is achieved. Hinge Pins Calfpad Legrest Hinge Plates Legrest Release Handle Removing 1. Push the legrest release handle toward the inside of the wheelchair (facing the front of the wheelchair) and swing the legrest to the outside of the wheelchair. 2. Lift up on the legrest and remove from the wheelchair. 3. Repeat STEPS 1‐ 2 for opposite side of wheelchair. Bolt/Nut FIGURE 9.13 Installing/Removing Elevating Legrests Part No 1141450 53 Pronto® M91™ with SureStep®