Invacare M91 Owners Manual - Page 49

SECTION 9-FRONT RIGGINGS 3. Perform one of the following: • Adjusting ‐ Align the appropriate mounting hole of the telescoping front rigging support with the front mounting hole in the seat frame tubes to achieve the desired depth as shown in FIGURE 9.7. • Replacing ‐ Perform the following steps: i. Remove the existing telescoping front rigging support from the wheelchair frame. ii. Insert the new telescoping front rigging support into the seat frame. iii. Align the appropriate mounting hole of the telescoping front rigging support with the front mounting hole in the seat frame tubes to achieve the desired depth as shown in FIGURE 9.7. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 4. Using the two socket bolts and locknuts, secure the telescoping front rigging support to the seat frame as shown in FIGURE 9.7. 5. If necessary, repeat STEPS 2‐4 on remaining telescoping front rigging support. 6. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 36. Inner Mounting Not Used Holes Mounting Bolts Seat Frame Telescoping Front Rigging Support Spacer Locknuts 87 6 5 4 32 Not Used Mountin g Holes Hinge Pins STANDARD POSITION 18 inches 20 inches 22 inches wide wide wide Holes 2 and 3 Holes 2 and 3 Holes 3 and 4 1 INCH OUT 18 inches 20 inches 22 inches wide wide wide Holes 3 and 4 Holes 3 and 4 Holes 5 and 6 2 INCHES OUT 18 inches 20 inches 22 inches wide wide wide Holes 4 and 5 Holes 4 and 5 Holes 6 and 7 FIGURE 9.7 Adjusting/Replacing Telescoping Front Rigging Supports Part No 1141450 49 Pronto® M91™ with SureStep®