Invacare M91 Owners Manual - Page 47
° Taper, Model PH904A and PHAL4A
View all Invacare M91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
SECTION 9-FRONT RIGGINGS 7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front Riggings on page 45. 8. Reinstall any accessories onto the footrest(s). 70° Taper NOTE: For this procedure, refer to FIGURE 9.4. 1. Remove any accessory from the footrest(s). Coved Spacer Mounting Screw 2. Remove the footrest from the wheelchair. Refer to Installing/ Removing Front Riggings on page 45. Heel Loop Footrest NOTE: Lay the assembly on a flat surface to improve access to the hardware. FIGURE 9.4 Installing/Removing Front Riggings - 70° Taper NOTE: Note the position of the spacers before disassembly. 3. Remove the mounting screw and coved spacer that secures the lower footrest assembly. 4. Position the footrest assembly to the desired height. 5. Secure lower footrest assembly with existing mounting screw and coved spacer. Securely tighten. NOTE: Make sure spacers are positioned properly when reassembling to prevent damage to the frame mounting tubes. 6. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front Riggings on page 45. 7. Reinstall any accessory onto the footrest(s). Model PH904A and PHAL4A NOTE: For this procedure, refer to FIGURE 9.5. NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way. Footrest Support Lug Bolt Locknut 1. Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. Lower Footrest FIGURE 9.5 Adjusting Footrest Height Model PH904A and PHAL4A 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary. Part No 1141450 47 Pronto® M91™ with SureStep®