Invacare M91 Owners Manual - Page 51
Adjusting Adjustable Angle Flip-Up Footplates
View all Invacare M91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
SECTION 9-FRONT RIGGINGS Adjusting Adjustable Angle Flip-Up Footplates Depth Adjustment NOTE: For this procedure, refer to FIGURE 9.9 on page 50. 1. Remove the two flat screws, washers and locknuts that secure footplate to the half clamp. NOTE: Observe the angle of the footplate for reinstallation. 2. Move footplate to one of four mounting positions. NOTE: If desired depth is still not obtained, rotate the half clamp on the footplate hinge 180°. 3. Retighten the two flat screws, washers and locknuts. NOTE: The settings for positioning the footplates on the half‐clamps may vary for each footplate. Angle Adjustment NOTE: For this procedure, refer to FIGURE 9.9 on page 50 and FIGURE 9.10. 1. Loosen, but DO NOT remove, the two flat screws, washer and locknuts that secure the footplate to the footplate hinge (FIGURE 9.9). Footrest Support Footplate Side View of Footplate and Footrest Support 2. Position the footplate to the necessary angle to accommodate the user (FIGURE 9.10). 3. Retighten the two flat screws, washers and locknuts. FIGURE 9.10 Angle Adjustment Perpendicular and/or Inversion/Eversion Adjustment NOTE: For this procedure, refer to FIGURE 9.9 on page 50 and FIGURE 9.11. NOTE: It is not necessary to remove the footplate to perform this adjustment. Front View of Footplate and Footrest Support 1. Insert a flathead screwdriver through the half clamp on the footplate (FIGURE 9.9). Footrest Support Footplate 2. Slowly turn nylon adjustment screw in or out until footplate is perpendicular to the footrest assembly or the desired inversion or eversion is obtained (FIGURE 9.11). FIGURE 9.11 Perpendicular and/or Inversion/Eversion Adjustment Part No 1141450 51 Pronto® M91™ with SureStep®