Invacare M91 Owners Manual - Page 50
Installing Adjustable Angle Flip-up Footplate Hinge, Installing Adjustable Angle, Flip-up Footplates
View all Invacare M91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
SECTION 9-FRONT RIGGINGS Installing Adjustable Angle Flip-up Footplate Hinge NOTE: For this procedure, refer to FIGURE 9.8. Footplate Hinge Mounting Screw 1. Position footplate hinge on the footrest support tube at the desired height. 2. Position mounting screw, washers, spacer, and locknut on the footrest support as shown (FIGURE 9.8). 3. Flip the footplate hinge to the up position. NOTE: The footplate hinge will fall to the down position. Locknut Washers Spacer Footrest Support FIGURE 9.8 Installing Adjustable Angle Flip-up Footplate Hinge 4. Tighten the mounting screw, washer, and locknut that secure the footplate hinge to the footrest support until the footplate hinge remains in the up position. 5. Check the up and down motion of the footplate hinge to make sure the user of the wheelchair can operate the footplates easily. NOTE: If footplateʹs motion is too tight, loosen the mounting screw and locknut approximately ¼‐ turn counterclockwise. NOTE: If the footplateʹs motion is too loose, tighten mounting screw and locknut approximately ¼‐turn clockwise. 6. Adjust footplate. Refer to Installing Adjustable Angle Flip‐up Footplates on page 50. Installing Adjustable Angle Flip-up Footplates NOTE: For this procedure, refer to FIGURE 9.9. 1. Slide the half clamp over the footplate hinge. 2. Hand tighten the two flat screws that secure the footplate to the half clamp. 3. Adjust the footplates to the necessary angle and depth for the user. Refer to Adjusting Adjustable Angle Flip‐Up Footplates on page 51. 90° Footrest Support Flat Screw Footplate Footplate Hinge Half Clamp Washer Locknut Nylon Adjustment Screw Half Clamp Footplate Hinge FIGURE 9.9 Installing Adjustable Angle Flip-up Footplates Pronto® M91™ with SureStep® 50 Part No 1141450