Invacare P9000XDT1818 Owners Manual - Page 34
Adjusting the Footrest Height
View all Invacare P9000XDT1818 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
SECTION 6-FRONT RIGGINGS Hinge Pins Footrest Release Lever Swingaway Footrest Assembly Hinge Plates Footplate FIGURE 6.1 Installing/Removing/Using the Footrest/Legrest NOTE: The footplate will be on the inside of the wheelchair when locked in place. Adjusting the Footrest Height NOTE: For this procedure, refer to FIGURE 6.2. NOTE: This procedure applies to the swingaway footrest and elevating legrest. 1. Remove the swingaway footrest assembly. Refer to Installing/Removing/Using the Footrest/Legrest on page 33. NOTE: Lay the assembly on a flat surface to simplify this procedure. 2. Remove impact guards and/or calf strap, if installed. 3. Pull the cam lock lever up to the unlocked position. 4. Push in the release buttons and reposition the lower footrest assembly to the desired height. 5. Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support. 6. Rotate cam lock lever down to locked position. 7. Replace impact guards and/or calf strap. 8. Repeat this procedure for the other footrest, if necessary. 9. Reinstall the swingaway footrest assembly. Refer to Installing/Removing/Using the Footrest/Legrest on page 33. Adjustment Holes Cam Lock Lever Upper Footrest Support Release Button Lower Footrest Assembly P9000™ XDT FIGURE 6.2 Adjusting the Footrest Height 34 Part No. 1118386