Invacare P9000XDT1818 Owners Manual - Page 57

SECTION 11-BATTERIES 2. Install battery clamp covers onto battery cables (Detail "C" of FIGURE 11.9): A. RED battery clamp cover onto RED battery cable. B. BLACK battery clamp cover onto BLACK battery cable. CAUTION When connecting the battery cable/ring terminal(s) to the battery(ies) clamp(s), the battery cable(s) MUST be connected in the position shown in Detail "A" of FIGURE 11.9. Otherwise, damage may occur to the battery cable and/or battery clamp covers. 3. Connect battery cable(s) to battery(ies) terminal(s)/post(s) as shown in Detail "A" of FIGURE 11.9: A. NEGATIVE (-) BLACK battery cable/ring terminal between the mounting plate and battery clamp of NEGATIVE (-) battery terminal/post. B. POSITIVE (+) RED battery cable/ring terminal between the mounting plate and battery clamp of POSITIVE (+) battery terminal/post. 4. Secure the battery cable(s)/ring terminal(s) to the battery clamp(s), BLACK to NEGATIVE (-) and RED to POSITIVE (+), with existing hex screws as shown in Detail "A" of FIGURE 11.9. Securely tighten. 5. Verify battery cable ring terminal(s) are correctly installed and securely tightened. 6. Slide battery clamp covers down battery cables and onto battery terminals as shown in Detail "B" of FIGURE 11.9. 7. Using 11½-inch long tie-wraps, secure each terminal cap in place as shown in Detail "B" of FIGURE 11.9. NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s). 8. Install the battery box top(s). 9. Install the battery box(es) into the wheelchair. Refer to Removing/Installing the Battery Boxes on page 49. NOTE: New battery(ies) MUST be fully charged BEFORE using, otherwise the life of the battery(ies) will be reduced. 10. If necessary, charge the battery(ies). Refer to Charging Batteries on page 47. Part No. 1118386 57 P9000™ XDT