JVC GYHD110U Instructions - Page 48
Warnings and Responses Cont'd - professional
UPC - 046838027345
View all JVC GYHD110U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
OTHERS Warnings and Responses (Cont'd) Error code • Warning Indications for VTR Abnormalities Should malfunctions occur during VTR operation, the unit self-diagnoses the cause and shows the diagnose together with an error code on the LCD monitor or in the viewfinder. Warning Error Code Error Details GY-HD110 Operation Remedy 0201 Indicates dew formation (condensa- Operation stops. All opera- Leave the unit with the power ON, until CONDENSATION ON DRUM tion). tions are rejected. the indication disappears. 3200 LOADING FAILURE Tape cannot be loaded. 3300 UNLOADING FAILURE Tape cannot be unloaded. 4100 Irregularity with eject operation. CASSETTE EJECT FAILURE Switch the power OFF and then switch it back ON. However, the tape may be damaged depending on the circumstances. Please consult the person in charge of professional video equipment at your nearest JVC-authorized service agent. 5605 - 5609 DEFECTIVE TAPE Tape is cut. Operation stops. Press the EJECT button to take out the cassette. If the tape runs out during recording, switch the power OFF and then switch it back ON, press the EJECT button, and then take out the cassette. 5702 TAPE END DET. ERROR 5802 TAPE BEGIN DET. ERROR 7001 DRUM MOTOR FAILURE 7101 CAP MOTOR FAILURE Tape end sensor error. Tape beginning sensor error. Drum rotation error. Capstan rotation error. Operation stops. All opera- Switch the power OFF and then switch tions are rejected. it back ON. However, the tape may be damaged depending on the circum- stances. Please consult the person in charge of professional video equip- ment at your nearest JVC-authorized service agent. 7202 - 7203 Supply reel rotation error. SUPPLY REEL FAILURE 7302 - 7303 Take up reel rotation error. TAKE UP REEL FAILURE 7305 Take up reel rotation error when un- TAKE UP REEL FAILURE loading. 8000 EMERGENCY TAPE! Tape problem detected. TURN POWER OFF. TURN BACK ON LATER. System error when power is turned on. HDV/DV LED, VTR indicator Turn off the power and let the unit sit and TALLY lamp flash. Only for sometime before turning it back on. POWER switch operation is accepted. 90 TALLY lamp Blinks when remaining battery power or tape is low. (Only in Camera mode) Blinking Pattern Slow blinking (once per sec.) Fast blinking (four times per sec.) Remaining Battery/Tape • Remaining battery power is low. • Remaining tape time is equivalent to less than 3 minutes. • Tape has run out. • Irregularity has occurred in the VTR. Alarm Sound When remaining battery power becomes low, a warning sound is output from the monitoring loudspeaker and the PHONES jack. (In Camera mode only) When an irregularity occurs in the VTR, a warning sound is also output. Whether or not alarm sound should be output and the volume level are selected with the ALARM VR LEVEL item on the OTHERS [1/2] menu screen. Depending on the alarm conditions, the warning indicators on the LCD monitor/viewfinder screen, the TALLY lamp, and alarm sounds appear as shown in the following table. OTHERS Alarm Indications on LCD Monitor/ Viewfinder Screen VTR alarm indication (Example) TALLY lamp I Alarm Sound Condition Dew formation (condensation) or error has occurred in the VTR. Display symbols J I J J : Blinking once per second. : Sound interrupted once per second. About 3 min. before tape end (displayed during recording). Tape end (displayed during recording). Remaining battery power is low. I : Blinking four times per second. : Continuous sound. 91