JVC GYHD110U Instructions - Page 51

Additional Information Presetting the Time Code from the LCD Screen The time code can be preset directly from the LCD screen without opening the TC/UB/CLOCK menu screen. CAUTION PRESET mode is not available in the following. • TC GENE. switch is set to REGEN. • TC DUPLI. item in the TC/UB/CLOCK menu screen is set to ON. • Menu screen is displayed. • RECORDING mode is active. • Switching to CAM/VTR mode (When VTR indicator is blinking). Setting Ⅵ TC/UB/CLOCK menu screen • Set framing of the time code generator in DROP FRAME. (When set to FRAME RATE 60/30) • Set to enable/disable user's bit recording in UB REC. (When set to FRAME RATE 50/25) Ⅵ Set the TC GENE switch to REC or FREE. MEMO See pages 40 - 41 for details on the above settings. Ⅵ Set the TC DISPLAY switch. Set to TC to preset time code and UB to preset user's bit. Operation This section describes presetting of the time code. VF BRIGHT USER 1 USER 2 USER 3 ND FILTER 2 1 MENU STATUS WHT.BAL AUTO AUTO AUDIO CH-1 LEVEL CH-2 ON OFF POWER REC USER 2 button USER 1 button USER 3 button USER 1 USER 2 USER 3 SHUTTER ND FILTER 2 1 OFF SHUTTER dial MENU STATUS button STATUS 1. In Standby or Stop mode, press the USER1 button for about 2 seconds while holding down the STATUS button. • The current time code generator data is displayed in enlarged display mode on the LCD screen. The hour digit starts blinking. Blink 2. Press the USER2 button to reset all data. • Data becomes "00:00:00:00" and the hour digit starts blinking. 3. Set the time code (hour, minute, second and frame). The blinking digit can be set. 1 Turn the SHUTTER dial to change the value of the blinking digit. Turn the SHUTTER dial up to increase the value and down to decrease the value. 2 Press the SHUTTER dial to change the blinking digit. 3 Repeat steps 1 and 2 and continue setting for each row. 4. Press the USER3 button to confirm the setting data. • The LCD screen returns to the original screen. Presetting User's Bit You can specify the user's bit with a number or character between 0 - F. CAUTION All digits of user's bit cannot be set to F. If all digits are set to F and read, user's bit is deemed as undefined during playback. Aborting Preset Operation While presetting, press the USER1 button while holding down the STATUS button. • Preset operation stops and the LCD screen returns to the original screen. CAUTION Ⅵ Preset operation is terminated in the following. • TC DISPLAY switch is changed • CAM/VTR mode switch is changed • VTR operations are performed Ⅵ USER1, USER2, and USER3 presetting in the SWITCH MODE menus screen is not available when the Time Code Preset screen is displayed. Ⅵ The time code preset screen is displayed on the LCD screen or viewfinder. It will not be output from the VIDEO OUT terminal. 48.5 EXTERNAL DIMENSIONS (unit: mm) * Design and specifications are subject to change without notice © 2006 Victor Company of Japan, Limited LST0533-