Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 User Manual with side - Page 102
Change the Fuses - Book Stacker, Change the Fuses - Side-Trimmer, Introduction, WARNING
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
5 - Error Conditions, Problems and Solutions - Change the Fuses - Book Stacker Change the Fuses - Book Stacker Introduction The Book Stacker has two fuses at the power input connector. See Figure 6 on page 6. If either fuse is broken, the Book Stacker will not operate. WARNING: Turn OFF the machine and remove the mains power supply cable before you change the fuses. This machine uses two fuses in parallel. WARNING: To avoid the risk of fire, replace fuses using only the same type and rating. Fuse Description • 3A, HRC Quick acting, F • Part Number 730-017 Procedure 1. Turn OFF the Book Stacker. 2. Disconnect the Book Stacker from the power supply. 3. Check each fuse. 4. If the fuse is broken then replace with a fuse of the correct specification. Result If the fuse breaks again, then call your Watkiss service engineer. Change the Fuses - Side-Trimmer Introduction The Side-Trimmer has two fuses at the power input connector. See Figure 7 on page 7. If either fuse is broken, the Side-Trimmer will not operate. WARNING: Turn OFF the machine and remove the mains power supply cable before you change the fuses. This machine uses two fuses in parallel. WARNING: To avoid the risk of fire, replace fuses using only the same type and rating. Fuse Description • 7A, HRC Quick acting, F • Part Number 730-018 Procedure 1. Turn OFF the Side-Trimmer. 98 Watkiss PowerSquare™224 User Manual